RICOH THETA Z1
User Guide

Connecting to a Bluetooth® Device

A Bluetooth® device can be connected to the camera.
Set the camera in advance so that the plug-in “REMOTE CONTROL” can be run.

  1. Turn on the power of the camera.

  2. Set the Bluetooth® device to a pairing state or connection standby state.
    • See the manual of the Bluetooth® device for details.
  3. Press and hold the mode button.

    • The plug-in selection screen is displayed on the OLED panel.
  4. Press the mode button to select “REMOTE CONTROL”.

    • flashes on the OLED panel.
  5. Connect the Bluetooth® device to the camera according to the manual of the device.
    • When the Bluetooth® device connection is complete, becomes lit on the OLED panel.

Note

  • After running the plug-in “REMOTE CONTROL”, the response speed of the wireless LAN slows down until the connection between the camera and the Bluetooth® device is established.

Disconnecting the Bluetooth® Device from the Camera

  1. Press and hold the mode button.
    • When multiple plug-ins are installed in the camera, select “REMOTE CONTROL”, and then press and hold the mode button.

    • turns off on the OLED panel, and the Bluetooth® device is disconnected from the camera.

Resetting the Bluetooth® Connection Information

When you want to connect another Bluetooth® device to the camera or when the device cannot be connected correctly, press and hold the wireless button and mode button simultaneously to reset the Bluetooth® connection information.

Caution

  • If you reset the Bluetooth® connection information, the wireless LAN password is also reset.
▲ Back to Top